Specific pickup wiring diagram

[pima1234]

I'm looking for a specific wiring diagram, if anyone can help, or suggest a better method of achieving all the switching possibilities.

2 splittable humbuckers with a middle single coil
Standard 3-way switch (LP style)
Push-pull on the master volume control to split the pickups (pulled is split)
Push-pull on the master tone control to activate/deactivate the middle single coil (pulled is active)

Both push-pull pots inactive: standard dual humbucker mode
Volume pot pulled: Tele switching
Volume & tone pots pulled: Strat positions 2, 3, & 4
Humbucker mode (volume push-pull pot inactive) + tone pot pulled (middle single active): Switch up = Neck bucker + middle single coil, switch in middle position = all 3 pickups, switch down = bridge bucker + middle single coil

Does that make sense? And thanks!

 

[Vhalen50]

if im following...youd want to find something like this here for a prs swamp ash special. The only change would be to keep the tone pot right side (single coil middle) on the switches. But then to move the tap wires, and resistor if you want, to a push pull volume knob and have both sides wired like a typical push pull coil split.

 

[pima1234]

if im following...youd want to find something like this here for a prs swamp ash special. The only change would be to keep the tone pot right side (single coil middle) on the switches. But then to move the tap wires, and resistor if you want, to a push pull volume knob and have both sides wired like a typical push pull coil split.

Awesome. Thank you.