shep
Inspired
I've been running 26.00 Beta 3 since it was posted. I've been using a FS-7 to control Preset Inc only and Scene Inc only perfectly for a few months. I'm running the FS-7 via a stereo send/ return cable into the FC-6 Switch 1 and 2 connector. Mono Tip is in Aof the FS-7, Mono Ring is in B. I took my rig into the living room to dial in my new LFR 212's and it still worked correctly. I brought it all back into my studio and now it's jacked up. Part 1 of the issue - The A side no longer increments the preset. I have not unplugged the cable to the Switch 1-2 and FS-7 tip/ring at all, only the FASLINK cable from the Axe Fx iii to move the board. I replaced the FASLINK and send/ return cables to no effect. I changed the send/ return cable to using 2 send/ return cables with A into Switch 1-2 and B into Switch 3-4and re-learned, then reversed the 2 cables going into A and B, re-learned - exact same response as original setup, so I think I'm about bad cable disproven.
I went back to original cabling setup after restart. I went into MIDI/Remote to re-learn the Preset Inc parameter (switched it to NONE beforehand), watching closely what it said this time. Oddly, while plugged into Switch 1-2 (Should read FC 1 SW 1) it reads Pedal 2.. When plugged into the Pedal 3 or 4 connector on the FC-6 it still learns the 'A pedal' as 'Pedal 2'. I reset it to None and switched the cable to Switch 3-4. Re-learn shows it as Pedal 2.
Meanwhile on FS-7-B pedal, It learns as FC1 SW 2 - correct. No matetr how I set the polarity or momentary/ latch switches on FS-7 the Scenes scroll 2-3 at a time, stop a second and do it again. It won't stop. Also, with the polarity as normal and using momentary settings, I could press on B and hold it and it wouldn't change until I let go of it. Now it changes on press no matter the settings. I tried updating to the 26.00 release version to no change. Call me waaay outta my depth here. Help me if you can, I'm feeling down And I do appreciate you being 'round...
I went back to original cabling setup after restart. I went into MIDI/Remote to re-learn the Preset Inc parameter (switched it to NONE beforehand), watching closely what it said this time. Oddly, while plugged into Switch 1-2 (Should read FC 1 SW 1) it reads Pedal 2.. When plugged into the Pedal 3 or 4 connector on the FC-6 it still learns the 'A pedal' as 'Pedal 2'. I reset it to None and switched the cable to Switch 3-4. Re-learn shows it as Pedal 2.
Meanwhile on FS-7-B pedal, It learns as FC1 SW 2 - correct. No matetr how I set the polarity or momentary/ latch switches on FS-7 the Scenes scroll 2-3 at a time, stop a second and do it again. It won't stop. Also, with the polarity as normal and using momentary settings, I could press on B and hold it and it wouldn't change until I let go of it. Now it changes on press no matter the settings. I tried updating to the 26.00 release version to no change. Call me waaay outta my depth here. Help me if you can, I'm feeling down And I do appreciate you being 'round...