Wish Power amp mode for certain outputs

[mlancaster1]

For users that are going direct to FOH and also using a tube power amp and cab, it would be amazing to be able to only have to use 1 amp block with 2 outputs and be able to disengage power amp modeling for certain outputs like disabling power amp modeling for only output 2 (or 3) going into a tube power amp.

I think the only way of being able to do this currently is by running two chains which will require duplicating effects chains and then having to engage and disengage two pedal chains using scenes. With this added capability, that would essentially eliminate the need to duplicate amp and effects chains just to toggle off this one option.

 

[unix-guy]

Been asked before, not possible.

 

[chris]

You can’t take power amp modeling or anything else out of the signal path at the end of the chain. It’s already affected the blocks after it.