Possible?

M

moore-fiend

Member
Hey All….my current fc 12 is set up with one amp/cab etc. What I want to to is leave this preset as is (4 scenes) and use foot switch one to access another preset for my clean tone. Is there an easy way to set this up on the 12?
Example:
Switch One: Preset 644 (clean)
Switch Two: Preset 671 Dirt
Switch Three: Preset 671 Lead
Switch Four: Preset 671 Lead (Flange)
Thanks everyone!!
 
perhaps saving the blocks from preset 644
And then creating (or replacing) a scene in 671 and assigning the saved blocks on an unused channel for each block and then save 671 as a new preset.
 
Scene switches select a scene in the currently active preset.

There's no switch that allows you to switch a preset + scene combination.

You might be able to use the Songs / Setlists stuff to do this for you.
 
WKSmith said:
perhaps saving the blocks from preset 644
And then creating (or replacing) a scene in 671 and assigning the saved blocks on an unused channel for each block and then save 671 as a new preset.
Click to expand...
I was trying to get around this but it did try it and it sounded off. Probably will try the song list option below.
 
You must log in or register to reply here.
Back
Top Bottom