TFC
Inspired
I am having an issue when I switch between preset 4 and preset 1 in a particular bank. Sometimes it works properly, but other times (maybe half or more) when I switch to preset 1 the volume is very low. I've attached the bank and user cab 3, which is used in preset 1.
To test:
1) install the bank
2) install the "TM TDR Acoustic.syx" file into user bank 3 (this is Fremen's acoustic IR)
3) go to preset 4 (BC MAIN)
4) Strum a chord and press switch 1 (P1) which will take you to preset 1 (Acoustic sim)
5) As the chord continues to ring out P1 volume should be about the same as P4.
6) Press switch 4 (P4) which will take you back to preset 4
Repeat steps 4 thru 6. When I do that, more often than not, the volume in Preset 1 is much lower than Preset 4.
If anyone else could try this and tell me if you get the same results I'd be grateful. And of course any suggestions for troubleshooting would be most welcome. Thanks!
To test:
1) install the bank
2) install the "TM TDR Acoustic.syx" file into user bank 3 (this is Fremen's acoustic IR)
3) go to preset 4 (BC MAIN)
4) Strum a chord and press switch 1 (P1) which will take you to preset 1 (Acoustic sim)
5) As the chord continues to ring out P1 volume should be about the same as P4.
6) Press switch 4 (P4) which will take you back to preset 4
Repeat steps 4 thru 6. When I do that, more often than not, the volume in Preset 1 is much lower than Preset 4.
If anyone else could try this and tell me if you get the same results I'd be grateful. And of course any suggestions for troubleshooting would be most welcome. Thanks!