Ping pong not ponging

[Exitetard]

I have my fm3 setup simple just into my studio monitors but when I set ping pong delay I’ve read (wiki)the first delay should sound in left speaker but I hear all the delays in both speakers I have cab set to stereo and both speakers panned 100% L and R. Had this issue with axe 2.
I’ve tried running one line of shunts and put it before amp or after amp or after cab no ping pong I’ve also set it up in parallel using Leon todds presets to go by. Specifically the morphing delay preset as well as create my own.

I have tried setting reverb after cab Incase cab wasn’t “stereo” and I’ve run out of ideas. I’ve messed around with neural dsp plugins and they pretty much come included with super spacious 3D sound. Specifically plini vst

 

[Wired]

Can you post a screenshot of your grid or the preset itself? The ping must also pong.

 

[hole]

Is the output set to stereo or sum L+R/Copy L->R? (in FM3 Settings, not in the patch)
If not set to stereo, then you wont get the ping pong effect

 

[Exitetard]

Can you post a screenshot of your grid or the preset itself? The ping must also pong.

Here’s some. Thanks guys I know it’s probably something in one of these wrong. I’ve tried swapping most everything in and out of parallel and before and after stuff so it’s probably a config setting

 

[Moke]

Out 1 is set to Sum L+R. Set it to Stereo

 

[Wired]

Yep, do what Moke said.

 

[Exitetard]

That was it thanks guys. Not sure why I had sum l/r on but I digress. All hail lord Leon. Time to get down with the Cygnus.