Level in Cab Block not working?

[Rogerthat]

For me, It seems like the cab/ir level knobs for both legacy and dynacab aren't working as expected. I've tried this on multiple amps and cabs and there doesn't seem to be a difference between -40 and 0.

This could be tested on any preset.

 

[painkiller]

With this control you can only adjust ratios between the speakers. If you use only one speaker the setting has no effect

 

[Rogerthat]

With this control you can only adjust ratios between the speakers. If you use only one speaker the setting has no effect

The level doesn’t seem to control the ratio between the cabinets.

 

[666was999]

The level doesn’t seem to control the ratio between the cabinets.

Use two IR slots in the same cab block and turn the knob.

 

[sprint]

The level doesn’t seem to control the ratio between the cabinets.

Within one cab block, adjusting the level on an individual IR slot does not change the overall level of the entire block - what is changing is the proportion that active IR slot contributes in relation to the other active IR slots - the level controls on the active IR slots act to obtain the active IR slot mix you prefer - they do not act to control overall volume.

 

[Rogerthat]

Within one cab block, adjusting the level on an individual IR slot does not change the overall level of the entire block - what is changing is the proportion that active IR slot contributes in relation to the other active IR slots - the level controls on the active IR slots act to obtain the active IR slot mix you prefer - they do not act to control overall volume.

Yeah. It doesn’t seem to do anything for me.

 

[sprint]

Yeah. It doesn’t seem to do anything for me.

Post a preset - I'll take a peek n see if I can spot an issue

(edit: I assume you have different sounding IRs loaded across multiple slots?).