mmcm4
Inspired
Just for fun, I put my Line6 M9 in the effects loop of the AxeFX-II and programmed my MFC-101 to control both the AxeFX-II and the M9 using MIDI. I've got it setup correctly and it's been working until an hr ago. When I bypass the FX block, everything works fine.
I've tried the following:
1. Resetting System Parameters
2. Checking the meters in the utility window
-> When the FX Loop isn't bypassed: Signal in L1 and R1, but nothing on either out
-> When the FX Loop IS bypassed: Signal in L1 and R1, and OUT L1 and R1
3. Shunting a cable between the FX send and return (i've tried several cables, in mono and stereo configurations)
4. Checked all the levels in the FX Loop blocks
It was working, but something happened. I don't know if I changed something, or if the AxeFX-II isn't detecting the cable in the FX Loop.
I've tried the following:
1. Resetting System Parameters
2. Checking the meters in the utility window
-> When the FX Loop isn't bypassed: Signal in L1 and R1, but nothing on either out
-> When the FX Loop IS bypassed: Signal in L1 and R1, and OUT L1 and R1
3. Shunting a cable between the FX send and return (i've tried several cables, in mono and stereo configurations)
4. Checked all the levels in the FX Loop blocks
It was working, but something happened. I don't know if I changed something, or if the AxeFX-II isn't detecting the cable in the FX Loop.