FW 15b Dizzy V4 4 Saturation switch issue [SOLVED]

[jsl2h]

Whenever this button is pressed in 15b it seems to cause i bit crushing effect. I noticed it within the first 5 mins of updating, and rolled back to v14.02 without issue. Just throwing it out there so in case no one has yet.

 

[jlynnb1]

Been discussed at length. There is no sat switch on those amps so now when engaged it was undesirable effects. Seems it will be this way going forward due to changes in the modeling algorithms.

 

[ocaptainjr2]

http://forum.fractalaudio.com/axe-f...ething-awry-dizzy-models.html?highlight=dizzy

May want to try these settings that Cliff posted and see if they make the Sat Switch work 'better':

"The problem is I put an extra zero after the decimal point on the CF Ratio so it's going to the minimum value of 0.1 which is far too low. For now use these settings:"

CF Compression: 70%
CF Time: 3.2 ms
CF Ratio: 0.38

 

[yek]

Should be solved in v15 final.