Scot Felton
New Member
Hey all - Using 2 amps for dirty/clean - can't figure out how to assign foot switch to switch between the two amps and turn on/off as needed. I don't want them both on at same time.
I have a signal chain going across one line of blocks with amp 1 - then directly below amp 1 I have amp 2 as I have seen set up in videos etc... - I put the ins and outs so it's connected to the chain as well as amp 1.
I'm not able to attach a pic - newb.
thanks for any advice!
I have a signal chain going across one line of blocks with amp 1 - then directly below amp 1 I have amp 2 as I have seen set up in videos etc... - I put the ins and outs so it's connected to the chain as well as amp 1.
I'm not able to attach a pic - newb.
thanks for any advice!