Thanks, never thought about using the global eq volume. Awesome!There's currently no way to lock the level. Gaffer's tape is your friend there.
One trick is to use the Level slider of the global Output EQ's to bring down the level so you can turn the physical output knobs up all the way. It can make it a bit easier to hit a consistent output setting that way. You can also tape the knob at your typical setting, and then use the global EQ level slider to fine tune the level up or down as needed.
I believe AdminM@ has posted that D'Adarrio's Loknobs will fit the output knobs on Fractal gear too.
https://www.daddario.com/products/a...andard/item/daddario-loknob-small-black-9519/
I'd love a copy of that file, please. thanksI printed a knob cover with my 3-D printer. If you have access to a 3-D printer, I’ll send you the STL file.
Sure thing. I’m just printing it now to make sure it fits. When it does, I’ll upload the STL file for you.I'd love a copy of that file, please. thanks![]()
I've done this on my FM3 and it works fantastically.You could put o-rings underneath the knobs, so that they are harder to accidentally be moved. I do this on all my pedals, never tried it on the Fractals.
Do you have pic?I printed a knob cover with my 3-D printer. If you have access to a 3-D printer, I’ll send you the STL file.
Works like charm! Didn't have to remove the knobs. Put these O rings around the knobs. Volume 1 has a smaller ring that keeps it in place, Volume 2 knob has a ring that's a tad bigger, allowing to turn.
Me too please and thank you!Sure thing. I’m just printing it now to make sure it fits. When it does, I’ll upload the STL file for you.![]()
I printed a knob cover with my 3-D printer. If you have access to a 3-D printer, I’ll send you the STL file.
This might eat a few % of CPU loadThanks, never thought about using the global eq volume. Awesome!
Thank you for STLSure thing. I’m just printing it now to make sure it fits. When it does, I’ll upload the STL file for you.![]()
Which size out of that kit fit the best?