FC-12 Screw ordering specs

reclavea

reclavea

Fractal Fanatic
I’m going to screw my FC-12 to a pedal board case.

Does any one have the ordering specs for these screws?

I need 3/4” - 1” length

I will be using the same tapped screw holes on the FC-12

Any tips as well

Thanks
 
ID454 said:
The original screws on the bottom of the FC-6/12 are M3.5-0.6 x 16mm
Click to expand...
The 16mm are what are people use to mount thru a Temple Audio board.

The originals are shorter...

But the other information is accurate.
 
  • Like
Reactions: Rex
unix-guy said:
The 16mm are what are people use to mount thru a Temple Audio board.

The originals are shorter...

But the other information is accurate.
Click to expand...

I think I’m gonna need at least a 25mm keeping the bumpers on? The board looks less than a 1/4”thick

Also what length would I need for the EV-2? With or without the rubbers?

Is there possibility of damaging the pedal with a too long screw?
 
reclavea said:
I think I’m gonna need at least a 25mm keeping the bumpers on? The board looks less than a 1/4”thick

Also what length would I need for the EV-2? With or without the rubbers?

Is there possibility of damaging the pedal with a too long screw?
Click to expand...
For the FC, only use the 4 corner screws.

No idea on the EV-2...
 
ID454 said:
The EV-2 does not have any internal components by the screw holes that you have to worry about damaging. A little too long could be fine.
Click to expand...

I took off a screw from the bottom of the EV-2 and used an appropriate size drill bit as a “feeler gauge” to test the depth.

The drill bit barely went past the depth of the original screw.

I took off all 4 screws to examine the interior but the bottom plate didn’t come lose. I guess it’s not a simple task of simply remove the 4 screws to get a look at the interior?
 
You must log in or register to reply here.
Back
Top Bottom