Dissembling an FC-12?

[sb-SG]

Hi.

Anybody taken a look inside their FC-12 ?
Need to gain access to one of the back panel sockets which I am pretty sure has a dry joint on it.
Rubber end cheeks on 3 screws then the rear and back panel comes off in one piece?
Doesn't look like rocket science but would appreciate experience before digging in with a screwdriver.
No shortage of electronic skills
Thanks.

 

[Tom Morris]

This is an FC-6 but should be the same. Had this open glueing connectors.

 

[sb-SG]

^ Cool. Much appreciated. Easy enough job but helpful to see this up front.

Thanks.

 

[Tom Morris]

Think you'll need to pull the bottom board tho. No big deal.

 

[sb-SG]

Aye - that looks to be correct - was kinda hoping there was some solder joints exposed on the top surfaces but the sockets are too close and shroud the pcb connections.
No bother and thanks again.