Chase Bliss MOOD in in/out 3 volume issues

[Marco Arroyo]

I am trying to use a Chase Bliss MOOD on some patches I have for some ambient textures. When I have the "loop" on using in/out 3, there is a noticeable volume and tone change.

How does everyone use an external pedal in a single scene in a patch without tone changes?

 

[Admin M@]

Hi Marco,

You are probably passing some dry signal through the MOOD as well. Set it to 100% wet. If that's not possible, use the method covered on p. 37 of the FM9 Owner's Manual for "Inserting Outboard Gear".

 

[chris]

Agreed.

If you can’t defeat the dry, move your “loop” blocks into the upper row (rather than parallel) and be sure to connect Out to In. Then turn off In 3 to “bypass the pedal.”