6160s preset, Perform-PP, Input EQ Low Cut, selects amp type [fixed]

holgar

holgar

Inspired
I am using preset named "6160s". When I am turning the knob of the INPUT EQ Low Cut, it selects a different amp type. DLY1 Mix pot alters a frequency as do CH01 and FLG1 Rate.

Sorry for misleading preset number in my first post.
 
Last edited:
In the Wrecked Express preset the Perform-PP has issues in my FM3 too.
The Amp1 Bright switch changes the amp modell. Mayby something went wrong from taking this page from the AxeIII.
 
In the "FAS Originals" preset, scene 4:
On the Perform PP, the Amp1 Low-Mid knob does not control the mids, but the Amp Boost switch. Also the other knobs do not correspond to the labeling. Is this only on my FM3? I am surprised that there is no reaction to my hint. I wouldn't care about this little error because I'm replacing this page with my own selection. I just thought it would be helpful.
 
I reported a similar issue with one of the new presets earlier as did another forum member. Here is Admin M@ response.

++++++++++++++++++++
Admin M@ said:
The cause of this has been found. I believe a new version of the banks will be required. We will produce these as soon as time permits.
 
You must log in or register to reply here.
Back
Top Bottom