Search results for query: *

  1. P

    Mojotone 7-string pickup demo - FW15.02 + UltraRes 4x12 Cab Pack 5!

    In this video we demoed our new Mojotone Level Head and Classic 7-string pickups through our Axe-IIs with firmware 15.02 and a bunch of different IRs from Fractal's new Ultra-Res 4x12 cab pack. We tracked everything direct and the amp/IR combinations are all spelled out on screen. The new...
  2. P

    More Axe-FX II + Mesa Mark IV Metal Fury! Predecessor - Skin Deep

    Here's another video of an instrumental version of a track from our new album. All guitars were recorded with an Axe-FX II with v12 firmware. The signal chain for rhythm guitars was an ESP NT-7 -> Duncan Distortion -> Axe FX-II (pre) -> Mesa Boogie Mark IV (power) -> Mesa traditional 4x12 ->...
  3. P

    v13 Firmware UltraRes 1hr Metal Challenge!

    I'd read a lot of good things about the new UltraRes IRs and wanted to see if I could dial in a patch from absolute scratch + track/film, mix, and bounce a 1 min video within an hour. I gotta say it was not difficult at all to dial in some very satisfying tones. I only tried the select UltraRes...
  4. P

    Axe-FX II + Mesa Mark IV power = Seismic tones

    This video is of an instrumental version of a song off of my band's new album. All guitars were recorded with an Axe-FX II with v12 firmware. The signal chain for rhythm guitars was an ESP NT-7 -> Duncan Distortion -> Axe FX-II (pre) -> Mesa Boogie Mark IV (power) -> Mesa traditional 4x12 ->...
  5. P

    Predecessor Album Teaser Video - Axe-FX II Crushing Metal Tones!

    Check out this teaser video for our new album Through the Winter's Cold for some crushing Axe-FX II-driven metal. All guitars were recorded with an Axe-FX II with v12 firmware. The signal chain for rhythm guitars was an ESP NT-7 -> Duncan Distortion -> Axe FX-II (pre) -> Mesa Boogie Mark IV...
  6. P

    Predecessor - v11 firmware w/ownhammer IRs

    Predecessor - high gain v11 firmware w/ownhammer IRs This is a track from our upcoming album Through the Winter's Cold. All leads, cleans, and textures were tracked direct using v11 firmware and an assortment of Ownhammer and fractal stock IRs. Rhythm guitars were recorded using the Axe II as a...
  7. P

    High gain drive (Envelope) Modifier - suggestions

    I'm looking to setup an envelope-follower controlled modifier on the drive setting of the amp block on my high gain rhythm patches. I've found that I'm able to dial in the correct amount of gain to taste, however when playing part of songs which call for very aggressive picking and dynamicly...
  8. P

    Multiband Compressor - tightening the low end in high gain rhythm gtrs

    I'd like to experiment with the multiband compressor in an attempt to tighten up the low end aspect of my tone for consistency throughout. I can address it later with the Waves C4 but feel like it might be better to go ahead and address it in the Axe to reduce the need for later processing. Any...
  9. P

    "Go-To" parameters for fine tuning top end in hi gain tone

    I'm finding that I can't quite dial in the top end aspect of my tone to be where I'd like it. I like the feel of the preamp and IR models I'm using, and almost everything about the resulting tone is right where I'd like it. However I can not seem to dial in the amount of presence and treble that...
  10. P

    SPDIF DI out for reamping and SPDIF level issues? Signal too low??

    I'm trying to capture the DI from my guitar while tracking using the SPDIF out but when i do so the level coming into my interface is low and I haven't seen any way to adjust for this on the Axe? Is there any way to increase the level of this out? Any other suggestions regarding the best way to...
  11. P

    Need help routing direct out via SPDIF??

    I would like to route a direct out signal out of the Axe II into my interface, while also recording stereo out of Output 1...what is the best way to go about doing this? Is there a way to change the FX loop output to SPDIF?
Back
Top Bottom