FC-12 MK2 Screen Failure.

[papajuice]

So I plugged in my FC-12 and noticed one of the LCD screen has lines in it. Kinda like the lines in your TV when it goes bad. Has anyone seen . this. Better pictures.

 

[Ole]

Can't see it in this photo. Try to adjust your contrast a bit lower.

 

[papajuice]

Better pictures now.

 

[JoKeR III]

If it's only one section of 3 switches, it could be as simple as re-seating the ribbon cable. Worst case could be a circuit board issue. IIRC, the switches are grouped in 3's on separate boards. Best course of action would be to contact Fractal Support to go through their troubleshooting process.

 

[papajuice]

If it's only one section of 3 switches, it could be as simple as re-seating the ribbon cable. Worst case could be a circuit board issue. IIRC, the switches are grouped in 3's on separate boards. Best course of action would be to contact Fractal Support to go through their troubleshooting process.

Yea it's only one strip doing it. I may take the side off and see if it's a ribbon.

 

[KFF]

I kinda like it! I nearly want some... if the contrast could make it pop a little more.

Hope you get it sorted. Gotta love the modularity, though. One loose ribbon, or one board to be replaced.

Good luck.

 

[papajuice]

Took the top off all strips are still super tight. Plugged in to just a 9V power and the scribble strip only has 3 marks. Where as the rest are fully light. Have an email in to Support. But they won't be in till Tuesday. At the worst it would be replace the module that has 3 top strips.