Virtual Capo Tracking Question

[sgplayer76]

Hello! I use the Virtual Capo in many of my presets and even when recording. It’s pretty straightforward and works well, but I would like to know more about the tracking parameter. I am currently using the default setting (Tracking 5.00) and shift -2. Should I increase the tracking when shifting down? My goal is to sound as close as possible to my guitar being tuned down two steps without actually changing from standard tuning.

 

[R900]

Joining the question)

 

[shredmechanic]

If you lower the Tracking value there is less latency but more artifacts. In my experience, this works well with single note lines however I've noticed a bit of "warble" with chords under gain so I tend to leave it at the default setting.

For tight metal rhythms I've noticed that if I bring the pitch down further than -2 steps I need to kick on a clean boost/OD to bring back some of the attack and high end on my tone.