6stringscott
Inspired
I have noticed this before but didn't really dig into it. Right now I see hear very distinctly that my sound with Input Trim statically set at 2.0 is *very* different than the sound with a scene controller set at 20% with all controller defaults (so a basic y=x linear function, no offsets or anything), and min=0.1 and max=10.
Is there something fundamental I am missing about scene controllers and how they work? The difference is WAY off with how I am trying it- like I need to go closer to 30% on the Scene 1 controller to get close to a sound with trim = 2.0, and it's still quieter and overall less cutting tone using the Scene controller... the tonal difference might just be a function of it being a little quieter- I can't quite tell. Then when I disable the Scene controller 30% and statically set trim = 3.0, it is dramatically different sound, more hair.
But bottom line, these are NOT equivalent settings as I would expect them to be.
I expect a minor rounding error because the controller min/max (y value in the equation) goes from 0.1 to 10.0 (tracking the trim values), while I am changing the scene 1 controller percentage (this is the x value) from 0 to 100. But this should be almost imperceptible.
Can others confirm this behavior? Or what am I missing?
Ax8 FW 7.02
See the pics for my setup. In this shot, the scene controller is at 30% which should be similar to Trim=3.0
Thanks in advance
Is there something fundamental I am missing about scene controllers and how they work? The difference is WAY off with how I am trying it- like I need to go closer to 30% on the Scene 1 controller to get close to a sound with trim = 2.0, and it's still quieter and overall less cutting tone using the Scene controller... the tonal difference might just be a function of it being a little quieter- I can't quite tell. Then when I disable the Scene controller 30% and statically set trim = 3.0, it is dramatically different sound, more hair.
But bottom line, these are NOT equivalent settings as I would expect them to be.
I expect a minor rounding error because the controller min/max (y value in the equation) goes from 0.1 to 10.0 (tracking the trim values), while I am changing the scene 1 controller percentage (this is the x value) from 0 to 100. But this should be almost imperceptible.
Can others confirm this behavior? Or what am I missing?
Ax8 FW 7.02
See the pics for my setup. In this shot, the scene controller is at 30% which should be similar to Trim=3.0
Thanks in advance