Reverb not changing channels

J

jasmeece

Member
Has anyone experienced the reverb not wanting to change channels at a scene change? I am using a big delay and reverb for some swells and I notice that the reverb stays on the original channel every time a switch scenes. Everything else is changing nicely. The scene manager shows the new channel but the verb doesn’t switch
 
What's your CPU use? If you're running close to the edge, changing channels on something like the reverb can cause enough momentary CPU use to slow down the channel change or even abort it if it stays high for too long.
 
i've not experienced that.

check that Scene Ignore is off. also be sure that the Scene is actually setup for that other channel. can you change to it manually?

and as iaresee says, watch your CPU. if your current channel Reverb is a low CPU but you're trying to change to a higher CPU Reverb on the next channel, it might not react the way you want.
 
You must log in or register to reply here.
Back
Top Bottom