Output 1(pre) & Output 2(post)

Finnster

Finnster

Inspired
What are most using for mono type rigs...like one guitar amp.

Stereo, Sum L+R or Copy L/R?

I know the manual says Stereo will work for mono rigs as long as you realize if you are using a stereo effect like a stereo delay you will only get half the effect.

It is defaulted to Stereo for both outs. I have left mine configured that way but curious if I am missing something.
 
I have INPUT 2(POST) set to 'Left Only' for my amps with effects loops. When using stereo effects I start by adjusting the 'Pan L' and 'R' to 0 and adjust to get the desired effect. I also use delays with the 'Config' set to dual giving me a lot more versatility with the delay block.
Going straight into the front of an amp, setting the OUTPUT 1(PRE) to 'Sum L+R' will allow you to get both sides of stereo effects without having to adjust the 'Pan' parameter.
 
Finnster said:
Did you notice any benefit? Less noise or better effect tone?
Click to expand...
Have not noticed a huge tonal difference. I don't have to pan effects left or right to here some of the "stereo" ones i.e. 2290 delay. As for noise I only have a little with one guitar and even then it is only when the bb pre or ruckus is used.
 
You must log in or register to reply here.
Back
Top Bottom