Need a new footswitch box....ideas?

[Tremonti]

Need to add a exp pedal(far left) to board. That 4 banger box I built using a box from Small Bear Electronics. But I need a box that is taller and skinnier, so I create room for that exp pedal. Ideas?

Also can the 1+2 and 3+4 have a tap AND hold function?

 

[Habuman]

These might be worth a try. I have not used them so cannot give any feedback.

https://ottercustomdesign.com/collections/extra-switches-for-fractal

 

[Old_Soul]

It looks like you may have a Pedaltrain board. Check out post #12 in the the linked below and zoom in on the board on the left; this is not my board. It is on a Temple Duo board, but holes can be drilled

https://forum.fractalaudio.com/threads/fc-6-sidecar-total-success.201964/#post-2525061

 

[Tremonti]

These might be worth a try. I have not used them so cannot give any feedback.

https://ottercustomdesign.com/collections/extra-switches-for-fractal

Yeah I just don't want to pay those prices, when I have it working now. Good thought though.

 

[Tremonti]

It looks like you may have a Pedaltrain board. Check out post #12 in the the linked below and zoom in on the board on the left; this is not my board. It is on a Temple Duo board, but holes can be drilled

https://forum.fractalaudio.com/threads/fc-6-sidecar-total-success.201964/#post-2525061

Thought of just doing this actually.

 

[Chromatizm]

But I need a box that is taller and skinnier, so I create room for that exp pedal. Ideas?

From the top photo it looks like all you need to do with this setup is to turn that small box for 90 degrees, put stickers accordingly, and you are good. Am I wrong? Well, maybe reprogram the box to have the same layout , so the Tune is still the top right switch, but it should give you enough space. WDYT?

 

[scottp]

@Tremonti "Also can the 1+2 and 3+4 have a tap AND hold function?"
All switches can have this as long as they are configured properly.

 

[strabes]

Rotate the existing box 90 degrees, drill two new holes in the top and move the jacks to the new holes.

At one point I had a two button switch velcroed to my FC12, you could do one of these on both sides of the main screen.

can the 1+2 and 3+4 have a tap AND hold function?

yes if you configure them as stand-in switches, meaning they're duplicating a switch that exists on one of your layouts. FC manual page 34.