gaps between patches when using scenes?

Aces

Aces

Member
I wondered if somebody could help as I have noticed recently that when I change between scenes there is an audio gap as the patch is changing. I was under the impression that changing between scenes should be unnoticable?
 
Check x/y state of amp block. If you use in all scenes x amps (or y amps) you have absolute no gap, changing from amp x scene 1 to amp y scene 2 results in a short gap. How is your cpu load?
 
I think the workaround for the x/y states on amps when changing scenes is just to use two different amp blocks. Having said that, I have not experienced any audio gaps when changing scenes.
 
You must log in or register to reply here.
Back
Top Bottom