Not a Bug FM9 and FM9 Edit both freeze and unresponsive with drive modifier

D

Dwecht

New Member
Hey ya'll, on my kitchen sink preset, I'm at just around 78%-78.5% CPU usage with 2 amps and 4 cabs, two on each block. I have 10 Modifiers active, 9 of which are assigned to control switch 1. After trying several times, I'm unable to assign the gain of Drive Channel A, or really any drive channel, without both the FM9 and FM9 Edit freezing up and becoming unresponsive. I've tried both on FM9 Edit and the unit itself, just freezes up each time. However, I'm able to assign modifiers to most, if not everything else no problem. Any thoughts?

Also - first time poster, not sure how to upload a screenshot of the preset....
 
i believe gain calculations require a lot of processing.

as a test, please remove some blocks to get your CPU down to around 50% or so, then try to add a modifier to the Drive Gain.

with your preset as described, it could just be too much CPU being used.
 
You are right on the edge of too much processor. I've changed my rule of thumb to <75%, I also run a "kitchen sink" preset. Not a bug for sure.
 
You must log in or register to reply here.
Back
Top Bottom