Curious. How are you guys attaching FASLink Adapters to your Axe/MFC?

moo cow

moo cow

Inspired
I'm about to switch over to FASlink adapters for both my Axe Fx and MFC gen 1's. I was curious how you guys using them are attaching them to your pedal board or on the unit itself.
I ordered some 8" ethernet cables and figured i'd attach them some way that would secure the adapters in a very firm manner to in case someone trips on the XLR it won't pull on the ethernet connections.
 
Attached to Pedal Board sideways (in front of MFC) so the XLR/Ethernet is horizontal to the MFC (less likelyhood of being stepped on).
 
Not sure if this is relevant to the question, but I originally had the AFX Mark 2 and the most recent MCF. I only needed a single adapter, and I attached it to the inside of my rack case with Velcro and ran a regular XLR cable to the MFC.
 
I use a 12" Ethercon cable from BTPA.com. Their Ethercon cables are very sturdy - both the cable and connector and protect the jack on the devices.
 
You must log in or register to reply here.
Back
Top Bottom