Hi
@clarky ! So I think I got the basics down: the principle is 2 amp hard panned, 1 amp switched to Y for a cleat tone, and 1 amp with balance back to center for solo work
The other bit of information I have is that for cleaning the amp you put a volume controller in front of them (and match them gain-wise) so to have lesser need of modifiers. The volume can be also bypassed per-scene (basically a scene based I modifier
)
I thought the mixer was a nice and simple idea, but since you are using scene controllers now, I guess you have to rise the PEQ level (to restore bass and highs to a cleaned amp) and lower the amp output level with the same scene controllers?
So what do you think if I go like this:
volume block --> 2 amps in parallel (output leve controlled by scene controllers) --> peq (and other effects) in paralell with amp signal (level controlled by scene controllers) --> PEQ for solo boost?
Also I'd love to see your preset which morph to synth. Is the synth used in parallel like the PEQ to restore cleans?