Axe II Clipping Out2 Only....Help!

RossE

RossE

Inspired
I'm setup for Out2 to go to an IEM system. My presets are all setup with an FXL block last in the grid (in connection only, no out). I'm clipping Out2, some presets worse than others, but all clipping. None of them clip Out1. I have the Level in the FXL blocks set to -80.00 to prevent that signal from going out through Out1 also, but that should only affect Out1 anyway. The utility menu meters do confirm Out2 is clipping while Out1 meters look good.

Problem something simple or stupid that I missed. Help???
 
If the level in the FXL block is set to -80 dB, I'm surprised you're getting any signal at all to Out1. If you brought that up to 0 dB, I bet both outputs would clip. Then you could reduce the Amp block level until the clipping stopped.
 
I figured it out. At some point I must have fat-fingered the Level2 knob on the Send page of the FXL block. Had it turned way up and then spread the problem by copying that block to my other presets.
No more clipping.
 
You must log in or register to reply here.
Back
Top Bottom