Oh damn, this will require revising the Drive Guide.
The Basic GUI page now reflects only the controls found on the actual pedal. In cases where the actual pedal does not have any tone controls a simple Tone control is included for convenience.
Drive types based on op-amp and diode clipping circuits now allow control over the type and quantity of diodes in the positive and negative polarity. For example, the user can select (2) 1N34A diodes for positive signal polarity and (1) red LED for negative. Experiment with the various diode types and quantities to obtain new and unique sounds.
You can tell which have changed by going to the "Adv" tab. If the diode type/number are listed the models have been updated.Curious which models have been changed and which haven't. I'll make it easier... ;-)
BB Pre
Bender Fuzz
Bit Crusher
Blackglass B7K
Blues OD
Esoteric ACB
Esoteric RCB
Eternal Love
Face Fuzz
FAS Boost
FAS LED-Drive
Fat Rat
FET Boost
FET Preamp
Full OD
Hard Fuzz
Master Fuzz
Micro Boost
Mid Boost
M-Zone Dist
Octave Dist
Pi Fuzz
Plus Dist
Rat Dist
Ruckus
SDD Preamp
Shimmer Drive
Shred Dist
Super OD
T808 Mod
T808 OD
Tape Dist
Timothy
Treb Boost
Tube Drv 3-knob
Tube Drv 4-knob
Zen Master
You can tell which have changed by going to the "Adv" tab. If the diode type/number are listed the models have been updated.
T808, Timmy, Ruckus, BB Pre, Rat.Which drive(s) are best to try for the new improvements?
In many cases I matched the names of the controls too. For example a Timmy has a Bass and Treble control but they're actually Low Cut and Tone controls. So I named them Bass and Treble. In one case I think I named it "Bass Cut" even though the pedal has "Bass". Or maybe it was "Bass (Cut)". Can't remember.Rely curious to see what this looks like.... The Basic GUI page now reflects only the controls found on the actual pedal. In cases where the actual pedal does not have any tone controls a simple Tone control is included for convenience.