gatesofcelestia
Member
Awesome! Fractal kicking some pants!
Check your copy settings on the I/O pageI have this issue with FW10.2
I have nothing plugged into input 2 and don't have an input 2 block in the preset, but on the front panel's meter bridge input 2 has one led on as if something is plugged in.
Smells good doesn't it??!!I smell 10.03......
Like a saturday BBQ with beers and friends!Smells good doesn't it??!!
Agreed...but I bet he is now focused on those last few pesky bits of FM3 FW........Nah. Cliff needs a break. He worked pretty hard for us the last two weeks.
Nah. Cliff needs a break. He worked pretty hard for us the last two weeks.
Should be fine to power cycle it. It loads the entire firmware file into memory before it unpacks it applies it. That means if it fails to copy it just abandons the process without attempting to change anything on the unit.Has anyone had any issues with updating to this firmware? My update froze at 73% during the file transfer and Fractal Bot states that it lost connection and to check to make sure the unit is powered on and to try again. I am hesitant to power off the unit for fear that it won't boot. Thoughts?
Check your copy settings on the I/O page
Thanks! I powered it off, crossed both fingers, stood on one foot, winked at it, and tried again. It worked!!
Might want to add that to the manual.
yes, load the firmware and play the damn thing!My axefx3 has never been turned on in over a year since I got it for Christmas , will it be ok to update it to 10.2 I dont even know what firmware is in it