soularflair,
I see that you also have a FCB1010 and I read your post saying
"I have a similar problem, but I do not even get a "MIDI IN" signal on the Axe-Fx when I press ANY button or move either pedal. It's like the Axe is just not seeing anything from the FCB1010.
I'm dead certain it is connected correctly, the MIDI leads work fine, etc.
I'm certain the Axe MIDI CHANNEL is set to OMNI and the DISPLAY OFFSET to 1.
The FCB1010 lights go on and off when buttons are pressed so it appears it's working fine.
I followed the instructions here: http://www.voes.be/fcb1010/pdf/fcb1010% ... ftware.pdf, and the intsructions above in this thread (setting the I/O on the Axe, etc)."
I'm having the exact same problem, did you figure out what the problem was?
Thank you,
Dave
I see that you also have a FCB1010 and I read your post saying
"I have a similar problem, but I do not even get a "MIDI IN" signal on the Axe-Fx when I press ANY button or move either pedal. It's like the Axe is just not seeing anything from the FCB1010.
I'm dead certain it is connected correctly, the MIDI leads work fine, etc.
I'm certain the Axe MIDI CHANNEL is set to OMNI and the DISPLAY OFFSET to 1.
The FCB1010 lights go on and off when buttons are pressed so it appears it's working fine.
I followed the instructions here: http://www.voes.be/fcb1010/pdf/fcb1010% ... ftware.pdf, and the intsructions above in this thread (setting the I/O on the Axe, etc)."
I'm having the exact same problem, did you figure out what the problem was?
Thank you,
Dave