Per Boysen
Inspired
Yesterday I was switching between presets that all contain a Looper block by the end of the signal chain and I was surprised to notice that the audio spinning in the loop was carried over into the Looper block of the new patch! As I recall this was not possible back in FW7 when I last tested this. Very cool, I must say. There is a "bump" though that I suspect having to do with the loop being re-triggered from its start point, so you have to be careful with your foot timing and maybe also make some masking instrument noise right at the Preset swap.
Looking good, doing Half jumps when layering results in a totally pristine sounding high pitched bell timbre. Now we're only waiting for the modulation options of Reverse and Half to be fixed. Axe-Edit displays these two parameter as open for modulation assignment but if you select an LFO for Modulation Source there is just nothing happening at all.
Looking good, doing Half jumps when layering results in a totally pristine sounding high pitched bell timbre. Now we're only waiting for the modulation options of Reverse and Half to be fixed. Axe-Edit displays these two parameter as open for modulation assignment but if you select an LFO for Modulation Source there is just nothing happening at all.