I can't install 1.15!
Fractal Bot stop at 17,5%
Fractal Bot stop at 17,5%
Thanks guys, it seems i'll wait next betaShould have read through the comments first. I also can’t revert to 1.15, I keep getting FBot timeouts, the best I’ve gotten was about 30% complete. Tried going straight from AxeFx to USB port (bypassing the hub) but it just got worse.
I don’t disagree, and I also just confirmed the inability to downgrade via fractalbot ....strongly suggest notFeels to me like this should be pulled sooner than later...
cliff just did.Please disable the link until you discover a solution!!
For those having difficulty rolling back you can use the emergency recovery mode:
1. Turn power off.
2. Press and hold Page < and Page >
3. Turn power on and continue to hold for a couple seconds.
4. Unit will boot into emergency image.
5. Update as usual.
For those having difficulty rolling back you can use the emergency recovery mode:
1. Turn power off.
2. Press and hold Page < and Page >
3. Turn power on and continue to hold for a couple seconds.
4. Unit will boot into emergency image.
5. Update as usual.
Anyone else having issue with Axe-Edit? If so please state Mac or PC. Thanks.
Maybe something where you can select the output mode for each row of the grid wouldn't be confusing.I toyed with the idea of having FRFR on the left and SS on the right but figured it would confuse people too much.
Here is a question. If we are not able to revert to previous firmware will we be able to upgrade to the fixed version?Should have read through the comments first. I also can’t revert to 1.15, I keep getting FBot timeouts, the best I’ve gotten was about 30% complete. Tried going straight from AxeFx to USB port (bypassing the hub) but it just got worse. iMac Pro, OSX 10.13.6. Axe Edit 0.09.21 is painfully slow as well.