X/Y switching with External Control?

Owczar

Owczar

Member
Hi!
Is it possible to control Amp X/Y switching via external control? I have boss footswitch connected to pedal jack in Axe, it is set to external 10. Then I can easily control for example bypass state for any block - but I can't find way to set X/Y switching - is it possible?
Thanks in advance!
Cheers!
 
In I/O menu CRTL page scroll down to AMP X/Y and change the default CC# (100 for AMP 1 X/Y, 101 for AMP 2 X/Y) to PEDAL
 
X/Y states aren't controlled using modifiers, they need their own separate setup. Go I/O -> CTRL, and scroll down until you find Amp1 X/Y, I believe the default is 100.

"100" is the CC you'd use to change X/Y, if you were using MIDI, but as you're using a switching pedal, you'll need to change it from "100" to "PEDAL".

Then, go I/O -> PEDAL (you may have already done this), and set the PEDAL TYPE to match your boss footswitch. Make sure PRESET INCR and PRESET DECR are both "OFF".

Because they're not done with modifiers, X/Y switching controls are global. If you want to get around this (use your footswitch to change X/Y states of different blocks in different presets), you could use different instances ("AMP1" or "AMP2", for example), or look into using scenes. This is all in the manual, if you haven't already had a proper, deep read through I would wholeheartedly suggest it :)

*edit* Ninja'd...
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom