Bug? X/Y in Rotary block

brianv4

Fractal Fanatic
I tried setting up the Rotary block with different speeds on X/Y (slow to fast). I reset the block parameters on both X & Y then adjust X to be slower, switch to Y and it loses volume and the speed follows X .
 
after more tweaking, seems anytime you "reset current effect type" in FX8-Edit, it affects both X & Y states. Although the Rotary block doesn't like being reset. If you reset X, then Y loses signal and vice versa.

XL+ / Axe-Edit just resets X or Y, not the entire block. Is this a bug in the FX8 / Edit or normal behavior?
 
Back
Top Bottom