• We would like to remind our members that this is a privately owned, run and supported forum. You are here at the invitation and discretion of the owners. As such, rules and standards of conduct will be applied that help keep this forum functioning as the owners desire. These include, but are not limited to, removing content and even access to the forum.

    Please give yourself a refresher on the forum rules you agreed to follow when you signed up.

Wish: CabLab3 IR alignment in mm units

Joe Bfstplk

Axe-Master
The cab block uses mm for aligning IRs.
CabLab3 uses ms.

Can CabLab be updated so it keeps the alignment range it currently has, but goes in 0.1mm steps, or at least the same steps that the cab block is capable of? It is currently not always possible to duplicate an arrangement of cabs in the cab block using CabLab3, which makes submixing them to save CPU sometimes impossible.
 
Top Bottom