When you load an IR, are speaker parameter defaults also loaded? (X/Y)

plyall

Power User
I ask because I was just messing around with switching between cabinets using the X/Y feature yesterday.

My intent was to compare Factory IR F026 (2x12 Boutique) to an IR I was mixing in Cab-Lab 2.0. I started out by accidentally loading the F026 into both the X and Y versions of the cabinet. Oddly, they sounded different. Upon looking closer, I saw that the Y Cabinet parameters looked like they were at some default levels, and looked mostly unlike what were set as the X parameters.

Are there suggested/default parameters that load with an IR, or are these completely up to the user to determine?

If the latter, are there any guidelines as to a good starting place to begin with the cabinet parameters?

Thanks!
 
Back
Top Bottom