rudomat
Inspired
my question: i´m running a wet-dry-wet rig...the amps´ lineout feeds the axe fx, which then goes to a matrix power amp and to two speaker cabs...now delay and reverb is is on nearly all of the time...when i want to add some modulation effect in front of the rev/del, the mod.fxs´ volume is much to low at 0dB...now i can of course raise the volume of this block up to 20dB, but this of course has influence on the following rev and del fx...what could i do here?
of course my rev and del is set to 100% wet, which means that the mod.fx will only modulate the 100% wet fx-signal, but when i increase the volume that sounds fine to my ears...but when i bypass this block then, the "pure" rev and del-signal will be much less loud...
thanks!
of course my rev and del is set to 100% wet, which means that the mod.fx will only modulate the 100% wet fx-signal, but when i increase the volume that sounds fine to my ears...but when i bypass this block then, the "pure" rev and del-signal will be much less loud...
thanks!
Last edited: