josephyballew
Inspired
I was working on a preset that was 92 percent when finished with Axe edit connected. All communication took forever to happen then froze. I rebooted both the Axe and the Axe edit. Now Axe edit and The Axe 3 will not communicate. If I rebooted my Axe to the same preset, the Axe would go to scene one but if I tried to go to scene 2 would freeze up. If I booted the Axe up and changed presets, the Axe was fine. I could not get Axe edit or Fractal bot to work. I had to uninstall the USB driver and reinstall it. All is good now. I am just guessing here, but I think the new firmware should consider 90% the new 100 percent max load. This was bad enough to destroy the old driver and lock down the Axe on that preset. I redid the preset and it is at 85% and all is good. The reinstalled fixed the driver. So before you decide to load up all you can, I would keep it under 90% until this is checked by the engineers. So I am thinking that bottle necking is happening at 90% and above, enough to destroy a driver.