Volume pedal setup question

Fro68

Fro68

Experienced
I have a EV2 pedal set up as a global output 1 volume control. It’s hooked up to my FC12 as FC#2.
Here’s my problem. When I sweep it to the heel position the volume lowers as expected until about 50%. From 50% sweep to 0% (heel down) I have no sound. It doesn’t gradually lower to silence.
I have calibrated the pedal and it shows to go through it’s sweep on the graph. I have also never had this problem in the past using pedal 2 as an output volume control.

I did download a footswitch layout for my FC12.

Anyone have any idea on what settings I need to check?
 
Are you using a known, good TRS cable? Kind of sounds like one side of the cable (or other wiring inside the pedal) is bad.

Edit:

Ignore my comments... I somehow missed the part about the calibration showing the full sweep ;)
 
Last edited:
Are you sure that it isn't also attached to something else in the preset itself?
 
You must log in or register to reply here.
Back
Top Bottom