What's your "Output 1 mode" setting in the I/O menu? Have you connected both channels of Output 1 (L & R) for monitoring?Im only hearing any delay when I turn up the "L" Time. When I have the "L" Time set at 1 ms, I can have the "R" Time set to 1000 ms and I dont hear any delay.
To add to this, born2lift, are you running in stereo with two channels coming out of your AxeFx? If going into a console or soundcard interface, is the first channel panned hard left, channel 2 panned hard right?What's your "Output 1 mode" setting in the I/O menu? Have you connected both channels of Output 1 (L & R) for monitoring?
If the sound is balanced left at the cab or output block, this could also cause what you described.
It's a stereo effect. You won't hear it nor will you get the effect in mono. If you're running one cab, it has to be a stereo cab with two feeds or you will not hear the right effect.I'm only using one cab for monitoring. I switched it to left right sum an not I can hear the delay, but it just sounds like spanky reverb.
I'll help you Chew...this HAAS delay trick is so close to what the enhancer block does I can't decide which I like better at the moment.
Classic enhancer mode is just a delay on one side (adjustable from 0 to 20 ms) plus pan & phase adjustment. The non-delayed side will tend to seem louder, just like if you used a delay block to get the same delay time.IThe enhancement block is perfect in the way it delays our signal and you won't notice any one side favoring another.
It may, but I've never been able to get that sound out of the cab block. Two different cabs in stereo *may* do it. But I've not played around enough to tell you for sure. It's rare I use stereo cabs....but when I have and messed with the delay times, I didn't get this effect.Sorry to revive an old thread. Would the delay in the cab block work for this too?