Using 2 guitar inputs (electric & Piezo) to 2 separate output

P

Piter Halim

New Member
Hi everyone... I'm quite a new AX8 user and very satisfied with this baby.

I've been trying to separate output from my Piezo signal but no luck. Its always mixed with electric signal in OUT1.

My routing is Electric signal ---> IN1 and Piezo ---> IN2 (FX RTN)

I know my signal path is somehow not right, FXL block ---> CAB block and go straight to Main Output.

How to separate the signal so I can get Piezo tone from OUT2?

Really need your advice guys....

Thankkkkzzzzzzzzzzz..........
 
electric in the front
piezo in the back (input 1 right)
set input 1 to stereo in I/O
make two rows and put a volume block at the beginning of each row
set input select to "left" in one volume block
set input select to "right" in the other volume block
you now have two completely separate rows for electric and piezo
at the end of the row that is set to "right", place the fxl block to send the signal to output 2
 
You will have better luck posting this in the AX8 forum.

The AX8 cannot duplicate this functionality in the same way that the AxeFX does it. The two posts above are not applicable to the AX8 since the AX8 does not have stereo (left and right) inputs for the main instrument input, or a mixer block as shown in the video. You have to use the FX loop as an input for the piezo. See factory preset 64-6 for an example.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom