brianv4
Fractal Fanatic
Forgot to unplug the MFC from the FAS link connection when I updated firmware in the Axe (17.03). Then I went to update the MFC to 3.06 via fractal-bot on a mac/presonus studiolive midi out/mfc midi (mfc powered by the adaptor).
The MFC goes into fw update mode but when I send the file it doesn't give me a % readout. When fractal-bot is finished the MFC is still showing "FW update mode". It works fine, just can't update it.
Did I screw it up? Perhaps tomorrow I'll try again going thru the axe instead. ugh.
The MFC goes into fw update mode but when I send the file it doesn't give me a % readout. When fractal-bot is finished the MFC is still showing "FW update mode". It works fine, just can't update it.
Did I screw it up? Perhaps tomorrow I'll try again going thru the axe instead. ugh.