UltraRes IR Mixing

E

erdosi

New Member
Hey,

I recently started to capture my own IRs on my AxeFXII XL+ and I purchased Cab-Lab 3.5 to create a mix of them.
However when I try to load the .syx files an error pops up that UltraRes .syx files are not supported, I should use .ir files that are created at the time of the capture.

The problem is I did not dump any .ir files when I captured my IRs.

Is there any way to use UR .syx files in CabLab?
or
Do I have to capture the IRs again and dump the .ir files?
or
Any other solutions/workarounds?

Thanks in advance for any useful input!
 
+1

I have been submixing my usual suspect IR pairs (57 and a ribbon or condenser) to get around the crackly noise in Cab2 block's IR #2 slot in the FM9, and can't mix some because they are in .syx format....
 
erdosi said:
Hey,

I recently started to capture my own IRs on my AxeFXII XL+ and I purchased Cab-Lab 3.5 to create a mix of them.
However when I try to load the .syx files an error pops up that UltraRes .syx files are not supported, I should use .ir files that are created at the time of the capture.

The problem is I did not dump any .ir files when I captured my IRs.

Is there any way to use UR .syx files in CabLab?
or
Do I have to capture the IRs again and dump the .ir files?
or
Any other solutions/workarounds?

Thanks in advance for any useful input!
Click to expand...
You could try this method and mix them on the unit itself:

https://forum.fractalaudio.com/threads/only-two-cab-slots-no-problem.180466/
 
Thanks for the tips, I ended up re-recording all of my IRs. Now with the .ir file saved as well, I can mix UltraRes without any problem.
 
You must log in or register to reply here.
Back
Top Bottom