Ultra 9.0.2: Drive block not delay compensated?

merlin17

Power User
Hi!

Putting a drive block in parallel with a shunt and bypassing the drive block (bypass set to Mix=0%) causes comb filtering.
 
merlin17 said:
Hi!

Putting a drive block in parallel with a shunt and bypassing the drive block (bypass set to Mix=0%) causes comb filtering.

It is not doing that here?
what is your routing?
 
Input - shunt - drive - amp ...

shunt in parallel to the drive block (connected to the shunt and the amp).
 
It IS delay compensated which is why you're getting comb filtering.

Why on earth are you putting a shunt in parallel with it and then setting Mix to 0? Makes no sense.
 
The drive block has a mix knob. Set it to 50%, boost the output level, and you've got scenario I imagine you're trying to create.
 
merlin17 said:
Input - shunt - drive - amp ...

shunt in parallel to the drive block (connected to the shunt and the amp).

Oh I see. Why?

Like Cliff said that is exactly why you are get comb-filtering, set it to mute to keep that from happening or just use the mix knob in the drive block.
If the wasn't like that the mix parameter in the drive would cause comb filtering. You are actually adding the non delay compensated signal w/ the shunt.
 
Back
Top Bottom