Tone Match and Cab Block?

BBN

Fractal Fanatic
I don't think there is a way to do this, but maybe I have a quarantine brain and am just not thinking straight.

I have a Tone Match (from my AxeIII) of my Marshall JMP1 and 100/100 rig.
It was done using a load box from the speaker output of the power amp, so that I can use it into a SS Power Amp and 4x12 cab.
I used the JMP OD1 amp block and the Tone Match gets it spot on to my rig (why did I do it if the JMP1 already exists in the AxeIII? - Because my rig with the 100/100 power amp just sounds different)
Anyway, the tone match sounds awesome. Mission accomplished.

I was thinking about bringing this same tone match into my AX8 as well. I was able to export the Tone Match out of the AxeIII and import it into the AX8. No problem.
Problem is - I'd like to use the AX8 with FRFR....but I already used my Cab block for the Tone Match file.
With only one Cab Block in the AX8 - is there any way to use a Tone Match and an additional Cab Block?
 
Back
Top Bottom