Tap tempo not working

Andy McGain

Andy McGain

New Member
I have a problem with the tap tempo button.
The midi lamp blinks when I tap the tempo but the tempo dosen´t change.
Suggestions?
 
Could you describe more in detail how you setup the tap tempo function?

If controller and Axe-Fx are set to the same channel (or A-Fx to "Omni"), and the switch you've chosen
for tap tempo sends a value of 127 on the CC number the A-Fx' tap tempo is set to, the tap tempo should work
and you'd notice that by the changing tempo of the LED.
 
Do you have a CC# assigned to TAP TEMPO in the Axe-Fx under I/O:CTRL?

Did you follow the instructions in the MFC-101 QUICK START GUIDE and perform a controllers reset on your Axe-Fx?

Also, since you didn't say... are you using Axe-Fx mode, Andy? Do you have all the signs that things are working correctly?

- Axe-Fx Preset Names show up automatically in the MFC-101 display
- Preset Change footswitches work
- IA Switches show effect states in red and green
 
Hi Matman!
Tanx for the reply!
Both TAP TEMPO and TUNER worked fine with the MFC-101 Firmware v0.18. When I uppgraded to MFC-101 Firmware v0.19 both tuner and tap AND all IA´s stopped working. I was able to configure the IA switches and assing them to effects and they all work except for tuner and tap.

I haven´t assigned a CC# to the TAP TEMPO.

I did follow the quickstart guide the first time I conected everyhing. And it worked. :) Untill I uppgraded the MFC..

Yes I use Axe Fx Mode and all the IA except tap and tuner works perfectly.

- Axe-Fx Preset Names show up automatically in the MFC-101 display. Yes they do.
- Preset Change footswitches work. Yes they do.
- IA Switches show effect states in red and green. Yes they do.

Suggestions?
 
You must log in or register to reply here.
Back
Top Bottom