Synth and chord progression for scenes

G

Gabriel Faz

New Member
Hi, I need to program a synth with scenes 1 = Cmaj 2 = Dmaj 3 = Emin, but I can not change the tone when I change the scenes. Could someone give me some advice?

Fremen has an Atmosynth Lead 5 scenes patch, but I do not understand how it changes the parameters in each scene.

Greetings and thanks.
 
Its using scene controllers.

Page 144 in the manual

7.3.7 Scene Controllers
Scene Controllers are similar to Manual Knobs above in that you manually set the value for each of two virtual
knobs that can be assigned as SOURCES for modifiers. Unlike Manual Knobs however, the value of each SCENE
controller can be pre=programmed individually for each SCENE in each preset. See p.184 for more on SCENES.
For example, you might assign SCENE CONTROLLER 1 to delay feedback, with a value of 10% in SCENE 1, 30% in
SCENE 2, 0% in SCENE 3, and so on. SCENE CTRL 2 could meanwhile be used for something completely different.
 
You must log in or register to reply here.
Back
Top Bottom