Switching channels on amp problem.

ATR1

ATR1

Inspired
FYI- If you have a relay block in FX8 unit you must delete block to use scene switching FX8-Edit.
Yesterday I had a problem with one of amps not switching in scene mode in an older preset I had. I use to place a relay block in the unit to switch channels. It took me awhile but I figured it out. I know someone will have this problem in the future.
 
Same experience here. I went through all my old presets to make sure no legacy relay blocks were there.
 
You must log in or register to reply here.
Back
Top Bottom