switching between scenes not consistant

randombastage

Experienced
I have a preset with three scenes. There are two different graphic eq blocks in the chain (passive 4 band). I have only one or the other GEQ block active in any scene.
Right now, switching in Axe Edit screen, using the scene selector buttons, starting with scene 1 button and then selecting scene 2 then scene 3:

Scene 1 has Geq#4 in x state.
Scene 2 has Geq#3 in x state.
Scene 3 has Geq#4 in y state.

that is how I wanted it.

However, if I then switch from scene 3 to scene 2 both eq's are active in x state. If I go through the scenes left to right it is good...going through them right to left scene 2 gets both activated.
 
To confirm whether or not this is AE or firmware related...
Have you run the above scenarios directly on the Axe and confirmed the state on the Axe ?
 
To confirm whether or not this is AE or firmware related...
Have you run the above scenarios directly on the Axe and confirmed the state on the Axe ?

Yes it happens from the front panel using the A knob to switch between scenes the same way as in axe edit. when connected by usb to axe edit or when paused in axe edit.

I've only tried it in one preset as I'm just starting to incorporate the passive eq's...
 
Back
Top Bottom