Switches layout

disruptoR

Member
Hi! My typical layout is based on scenes + stomp. By default, the system is set to scenes mode. In scenes mode, I usually use 1-2-3 for scenes, 4-5-6-7-8 to de/activate single effects. I'd like to know if it would be possible to use F2-F3 as two more switches to be assigned to either scenes and stomps. So I would use 1-2-3-4-F3 for scenes, 5-6-7-8-F2 for single effects.

Thanks!
 
unfortunately no. the F-Switches have limited functions and aren't freely assignable. check the owner's manual for that list of available functions.

keep in mind that what you're describing isn't actually "scenes mode." it's just a custom setup on the main "layer" of footswitches that you happened to put some Scenes on.

there is actually a "Scenes Mode" that is accessible with the F-Switches. this changes the functions of the 8 main switches to change Scenes 1 - 8. so be careful calling your custom setup "scenes mode" as it could be confused with the actual Scenes Mode that exists.
 
Back
Top Bottom